1) WHAT DOES THE MRF 250 DO?

2) DOES THE MRF 250 COMMUNICATE TO EQUIPMENT USING RADIO FREQUENCY DIRECTLY?

3) HOW MANY COMPONENTS CAN BE CONTROLLED USING THE MRF 250

4) CAN THE MRF 250 CONTROL IDENTICAL COMPONENTS?

5) HOW MANY MRF 250’S CAN I USE IN ONE HOME?

6) WHAT FREQUENCY DOES THE MRF 250 OPERATE ON?

7) HOW DO I PROGRAM AN MRF 250?

8) MY MRF 250 IS NOT RELAYING COMMANDS ACCURATLY TO MY COMPONENTS.

9) WHICH REMOTE CONTROLS ARE COMPATIBLE WITH THE MRF 250?

Using RF capabilities, the MRF 250 will allow you to operate equipment without having to point your remote. Radio Frequency operation will provide you control up to 100 feet through walls and cabinet doors.

The MRF 250 does not communicate directly to equipment via RF. It will only receive RF signals from the remote then relay that signal to equipment using an IR emitter or through the front IR blaster.

The MRF 250 can control up to 20 components using its front blaster or up to 6 components using the IR emitters.

Yes, the MRF 250 can control identical components. This is accomplished by using the IR routing feature. Each rear panel emitter output can be assigned to identical components and still address each one independently, even though they operate using the same codes.

The MRF 250 features RF addressability which will allow you to set up 15 MRF 250’s to control up to 15 different equipment locations in one home if desired. Each MRF 250 in the home can be assigned a unique ID address so that only certain authorized remote controls can access equipment in a specific setup.

The MRF 250 operates at 418 MHz.

Programming for the MRF 250 is accomplished through the remote controls RF setup menu either through the MX Editor software or manually depending on which model remote control you are using. There is also a dial located on the bottom of the MRF 250 that allows you to match your ID address to your remotes ID address.

A few variables come into play when setting up your MRF 250. It is important to eliminate any common oversights by referring to the setup steps outlined in the instruction manual.

Any of the RF addressable remotes will operate with the MRF 250. These include the MX350, MX650, MX800, MX850, MX900, MX950, TX1000 and MX3000